The following chutes and accessories are designed to compliment the various Kwik Dump Valves.
- 24" Extension Chute
- Shown Alone
- Slip-on 24” extension chute to allow water flow to extend past the back or side of the truck.
- Part #268055130
- 36" Extension Chute
- Shown Alone
- Slip-on 36” extension chute to allow water flow to extend past the back or side of the truck.
- Part #268055150
- 48" Extension Chute
- Shown Alone
- Slip-on 48” extension chute to allow water flow to extend past the back or side of the truck.
- Part #268055170
- 90-Degree Elbow Chute
- Shown Alone
- Elbow chute designed to enable dumping to the left or right. The elbow chute is tapered to slip over the valve and our slip-on extensions fit over the opposite end to extend to the side of the truck. Standard outside dimensions are 26” x 26” overall. Special elbow chutes can be built to your specifications, adding length to either end.
- Part #268055190
- 12" Flip Chute
- Shown on Model 1050 Valve
- Simple add-on flip chute to help direct the flow of water out of the valve. This chute can be mounted on any Newton Kwik-Dump valve.
- Part #268055210
- 36" Telescoping Chute
- Shown alone
- Telescoping chute to extend 36” beyond the end of the valve. Total length from tank when fully extend is 60”. Slides back to fit over the valve in 24” space. Can be mounted on any Newton Kwik-Dump valve. The model 4036 can also be retrofit on any Newton valve in service. Special short extensions for use on special short valves can be built to your specifications
- Part #268055230
- Lock-Open Device
- The Lock-Open Device will hold any Newton Kwik-Dump valve in an open position to allow operator to step away from the valve. The device can be factory installed on any new valve or installed in the field on any existing valve. When fully extended the device will lock automatically. To release it, simply lift the sliding bracket out of the notch and close your valve.
- Part #268060120
