The monitor base assembly and discharge sections are joined by full lengths (21'/6.4m) of 4" (10 cm) nominal diameter schedule 40 galvanized steel pipe (male thread one end, female coupling other end). The quantity of pipe lengths can be 1-5 depending upon the desired height of the monitor after fully engaging the threaded ends. A .25" (6mm) long fillet weld (2 at each thread) is recommended to prevent unscrewing. Two reaction supports supplied with basic unit. One support should be within 15' (4.5m) of nozzle. Additional supports may be added if desired and should be spaced 20' (6m) apart.

FEATURES:

• WFR monitor of standard industrial construction
• 360º horizontal motion ± 45º degrees vertical motion with position locks in each plane
• Standard red epoxy finish for monitor
• Stainless steel elevation control cables
• Hot dipped galvanized waterway and drive tube
• Ready to install, no field assembly required
• Pipe sections are unpainted galvanized

• Fog nozzles 
• Above ground intake base assembly
• Manual drain for freeze protection
• Additional reaction supports (20'/6m intervals)

Part #443515080