The monitor base assembly and discharge sections are joined by full lengths (21'/6.4m) of 4" (10 cm) nominal diameter schedule 40 galvanized steel pipe, T and C. The quantity of pipe lengths can be 1-5 depending upon the desired height of the monitor after fully engaging the threaded ends. A .25" (6mm) long fillet weld (2 at each thread) is recommended to prevent unscrewing. First reaction support (supplied with basic unit) should be within 7' (2m) of nozzle. Additional supports should be spaced 20' (6m) apart.
FEATURES:
- WFR monitor of standard industrial construction
- 360º horizontal motion ± 45º degrees vertical motion with position locks in each plane
- Standard red epoxy finish for monitor
- Stainless steel elevation control cables
- Hot dipped galvanized waterway and drive tube
- Ready to install, no field assembly required
- WFR shape tips
- Fog nozzles (hydraulically operated or cable operated)
- Flow straighteners to maximize reach
- Above ground intake base assembly and inlet butterfly valve
- Manual hydraulic pump (for fog nozzle actuation)
- Pump to nozzle installation kit/remote swivels grease kit
- Automatic/manual drain for freeze protection
- Heat shield
- Additional reaction supports (20'/6m intervals)
Part #443515100
