- Electronic Siren & Light Control System combined
- System flexibility
- Power versatility – 58, 100, 200 watts
- Optional SignalMaster™ directional light control
- "Air Bag Wise" control head
- Easy action rubberized key pad
- Control buttons back lit with soft red glow
- Simple to install
The SmartSiren system consists of an amplifier/relay unit and control head for complete electronic siren functions, full control of the vehicle's warning lights, and provision for switch control of up to six auxiliary circuits. A four-position slide switch is standard on the control head. A second model (SS2000SM) combines the light and siren operations with SignalMaster directional light control. In addition to the standard siren tones (wail, yelp, hi-lo, and manual), advanced features such as horn ring transfer, radio rebroadcast, TAPII, and PA are available. Provision is made to allow installation of a user-supplied switch, such as a foot switch, to activate lights and siren in the pursuit mode.
The SmartSiren system can drive one or two high power (100 watt) or low power (58 watt) 11-ohm speakers. For control of lights and other auxiliary functions, eight relay outputs are available. One output is fused at 40 amperes, two at 20 amperes, and five at 10 amperes. In addition, the model SS2000SM offers control of up to seven distinct signaling patterns (three directional and four flashing warn) ont he six or eight lamp SignalMaster units. An LED display on the control head emulates the warning pattern being executed by the directional light.
A major feature of the SmartSiren system is its ability to be configured at the point of installation. Selection of features is done from the rubberized push buttons on the control head, without disassembly or removing the unit from its mounted location.
Super Slim Control Head
SmartSiren is operated by the "Air Bag Wise" control head. When
installed properly, the
control head will not interfere with the deployment of either the driver or passenger
side air bag. (For safe equipment mounting zones in your vehicle, consult your car
manufacturer's recommended guidelines.) Two rows of rubberized switches (three on the
model SS2000SM) and slide switch allow simple control of emergency vehicle's warning
lights, siren, and auxiliary functions.
Simple Installation
The amplifier/relay unit can be remotely located and connected to the control head
via a 20 foot telephone cable with telephone-type connectors at each end. A mounting
bracket (supplied) allows the assembly to be located in a variety of positions. To utilize
the unit's public address feature, order microphone model MNCT. When the amplifier is
remotely mounted, extension cable (model RMK) must be obtained.
SmartSiren Features
- Slide switch modes 1-2-3 can activate one or more light and siren functions.
- Push buttons can be specified to be push-on/push-off or momentary type.
- Eight-second timer can be programmed to any switch function.
- Replaceable function labels identify the switches. A sheet of applicable function legends is supplied with each unit.
- "Park Siren Deactivator" siren is deactivated when vehicle transmission is put into park.
- Audible chirp feature reminds user of the active status of the siren unit.
- Wail, yelp, hi-lo, air horn, manual, priority, and horn ring transfer.
- Program mode disable to prevent unauthorized reprogramming.
- Siren tones and lights can be configured independent of each other.
- "Power Up' siren tone may be selected (wail, yelp, hi-lo, or priority).
- Each slide switch position can be configured to operate any combination of eight relays, PA, horn ring transfer, and siren enable.
- Any key on the siren row, except STBY, can be enabled or disabled.
- Control of up to seven distinct signals of the SignalMaster directional light.
- Configuration of the slide switch positions to operate any combination of eight relays, PA, horn ring transfer, siren enable, and any of the four SignalMaster warn patterns.
