LIGHTING / VEHICLE
Go Back

Stealth Strobe Mini Bar Magnetic Mount

Installation:
  1. Place magnetic based Stealth on a clean steel surface.
  2. Run cord inside vehicle in a manner so that it will not interfere with air bag deployment.
  3. To operate light, plug cigarette adapter plug into cigarette lighter. Make sure lighter is clear and free of dirt, rust, etc. Lighter should be fused at 15 amps.
Warning: The steel content of vehicles roofs varies considerably and some may not be suitable for mounting warning lights with magnetic bases. It is the sole responsibility of the users of magnetic based lights to determine if portable warning lights may be safely used.


 

Stealth Strobe Mini Bar Permanent Mount

Installation

  1. Place Stealth on area where it will be mounted. Using mounting legs as a pattern, mark all four holes to be drilled.
  2. Locate and mark hole for power cord.
  3. Drill 1/4" holes in mounting surface for mounting legs and power cord.
  4. Place Stealth with mounting legs over mounting holes. Place one rubber grommet between mounting surface and mounting leg. Repeat on remaining legs. Use 1/4" bolt and place bolt through leg, grommet and mounting surface. Attach washer and bolt, tighten securely.
  5. Place red and black wires  through hole for power cord. Connect red to 12-volt power at switch (not included). Fuse for 15 amps. Attach black wire to ground.

 



Back to Top
Click here to go to WFR's Home Page
Copyright © WFR Wholesale Fire & Rescue Ltd.