LIGHTING / VEHICLE

Go Back

LED Micro-Lite Kits

Instructions - Four Light Kit

1. (a) LED Installation With Bracket
   Cut out the recessed hole, Point A, on each end of the LED Micro-Lite. (NOTE: The recessed holes can only be seen from the bottom of the light.) See Figure 1. Attach the brackets to their desired location using the (8) longer screws. Then place the Micro-Lites into the brackets and attach them using the shorter screws and locknuts. The (4) gaskets will not be needed.
   (b) LED Installation Without Bracket
   Cut out the recessed hole, Point B, on each end of the LED Micro-Lite. (NOTE: The recessed holes can only be seen from the bottom of the light.) See Figure 1. Drill the (8) holes on the mounting surface for the (4) LED Micro-Lites using an LED Micro-Lite as a guide. Place the (4) gaskets under the LED Micro-Lites. Attach the LED Micro-Lites using the (8) longer screws provided. The (4) brackets, (8) shorter screws and (8) lock nuts will not be needed.
2. Mount the 11.1005SF or 11.1005 LED Flasher using the (2) provided screws.
3. Mount the 11.1002 LED Double Switch using the (2) provided screws.
4. Connect the wires as shown in the diagram below.
5. Connect the switch wires to the terminals on the back of the switch as shown in Figure 2.
6. After all other wires have been connected, connect the fused red wire to a +12V power supply.
   

Copyright © WFR Wholesale Fire & Rescue Ltd.