LED Micro-Lite Lights
Instructions - Single Lights
Bale Mount
- Look at the back of the Micro-Lite and locate the side knock-out holes.
- Use a small pointed instrument (like a screwdriver) to carefully punch out the holes.
- Attach the bale-mounting bracket (supplied) to the Micro-Lite with the short screws and nuts provided with your light.
Flush Mount (using screws)
- Look at the back of the Micro-Lite and locate the front knock-out holes.
- Use a small pointed instrument (like a screwdriver) to carefully punch out the holes.
- Position the enclosed foam gasket between the Micro-Lite and the mounting surface. (The gasket helps provides moisture control.)
- Attach the Micro-Lite with the long screws provided with your light.
Flush Mount (using double-stick adhesive tape)
- Make sure the mounting surface is clean and dry.
- Cut the adhesive tape (not provided) to completely cover the back of the Micro-Lite – using the enclosed foam gasket as a template. Cut out one oblong area to slip over the wires.
- Slip the tape over the wires, then peel off the paper backing on the side of the tape that will adhere to the light. Press the tape firmly for good adhesion.
- Peel off the remaining paper backing. Press the light firmly onto the mounting surface.
