Extenda-Lite Pull-Up Models with Flush Mount Brackets (FM)
Mounting Instructions
- Unpack the shipping box. Inside you will find an Extenda-Lite pole assembly
that is totally prewired with two (2) "U-shaped" Flush Mount Brackets,
FM.
- Inspect the box and all items inside for damage. Report any damage to the
delivering carrier immediately. If there is any damage, save the box and all
packing materials.
- Select the location for your new Flush Mounted Extenda-Lite. Try to have a
minimum spacing of at least 18" and a maximum of 50" between brackets
for mounting. Make sure there are no pipes or wiring that will be damaged when
the mounting holes are drilled.
- If your new Extenda-Lite does not fit where you want to mount it, contact us
immediately for assistance.
- Make sure pole and brackets are square and parallel to each other with
adjacent vertical lines. Mark, center punch and drill each of the four (4)
5/16" holes for each FM Bracket.
- With pole in place, bolt brackets into the holes drilled in step five, do
not over tighten. Slide pole assembly up or down to adjust the light head for
the desired level and overall stowed height. Finish tightening the bracket
mounting bolts and the two (2) 1/4 x 20 stainless steel set screws in each
bracket so the pole can not move up or down.
- Each Pull-Up, Flush Mounted Extenda-Lite is a permanent installation and
requires a licensed electrician do the wiring on all 110/220 volt, AC electrical
circuits. Extenda-Lites and all electrical equipment must be wired to a properly
protected circuit breaker box following all National Electrical Codes.
Note: A convenient way to run cords through the body panels or into the
compartments is with the use of a Hubbell SHC-1022 strain relief or its equal.
This will give you a water tight sealed connection and wire protection all in
one.
Black wire to circuit breaker's hot side.
White wire to breaker box's neutral bar.
Make sure all wires are ran in areas that will not be hit or abraded. Use wire
ties to hold securely in place.
|
