|
|
The Junction Box gives you the opportunity
of having any receptacle configuration that your application might require,
located in one 9-1/4"W x 5-1/2"D x 8-1/2"H, incredibly durable
drop box. The Junction Box's heavy duty, cast aluminum case and large integral handle makes it easy to carry, even with a gloved hand. The case is made of quarter inch thick aluminum on all sides and has one half inch thick reinforced corners. |
|
|
EJB-Flanged Inlet |
||
|
|
The Junction Box is designed to give maximum
protection to all internal electrical parts and basically offers years of
trouble free service.
Each side of The Junction Box is fitted with quarter inch thick, polypropylene faceplates that are back lighted with a 25 watt lamp. The bright back lit receptacle panels make The Junction Box easy to locate, and allows easy and correct orientation of plugs to the receptacles, even at the darkest work sites. |
|
|
EJB-With Pigtail & Plug |
||
|
|
You can choose from either a fully recessed inlet
plug, or you can specify a one foot pigtail with any NEMA plug configuration. If
you desire to have The Junction Box wired directly to your permanently
mounted cord reel, you must comply with NFPA-19.11.7.4 circuit protection. The
Junction Box complies with all current NFPA requirements. |
|
| EJB-Direct Wire | ||
|
|
Each back lit faceplate is installed with two standard receptacles. You may have a single, duplex, or combination of both receptacles on each side. Each receptacle if covered with a deluxe heavy duty spring loaded, snap type, weatherproof cover. Each cover is imprinted in white with the voltage and amperage rating of that receptacle | |
|
Parts Diagram |
