- Unpack the shipping box. Inside you will find an Extenda-Lite pole assembly
with the DayMaker Light Head unattached to the pole.
- Inspect the box and all items inside for damage. Report any damage to the
delivering carrier immediately. If there is any damage, save the box and all
packing materials.
- Carefully lay the pole assembly on a flat surface and position the DayMaker
Light Head so it lines up with the U-shaped bracket that is already mounted on
the top of your new Extenda-Lite pole assembly.
- Install bolts, nylon washers and self locking nuts as per the diagram below.
Tighten up the nuts so that the DayMaker Head has a friction tight fit and tilts
when pushed or pulled. It is now time to carefully push the excess wires that
are encased in the black shrink tubing up and into the DayMaker Bar on the side
that does not have the switch. Next install the hole cover to give the bottom of
the DayMaker Bar a finished look.
- Follow the attached mounting instruction sheet for FM, SM, TM, TR, or SB
mounting brackets.
|
