1. The blower can be used to blow air into a tent or remove air from it.
2. Do not use the blower for any other purposes as described above.
3. Use of the blower normally is without danger
4. To prevent technical faults, do not expose the blower to wet surroundings.
5. NEVER absorb water in air hose!!
6. The blower can not be operated while standing in a pool!
7. Never spray water on the blower
8. Be aware of accidents by electric pulses.

TECHNICAL DATA

• Motor: 240 V / 50-60 Hz
• Power 0,96 kW
• Speed 18000 l/min.
• Max. pressure at outgoing air connection 0,25 Bar
• Negative pressure depending on slide position: - 0,2 …. 0.075 Bar
• Housing steel plate silver grey, hammer tone finish
• Weight 7,8 kg
• Hose ca. 2 meter

OPERATION

• Set up the blower so that it is secure and stable
• Connect the plug to the electrical power supply
• Connect the hose assembly either to the pressure side connection or the suction side, depending on the required mode of operation.
  · suction – remove air
  · blow – fill with air
• Connect the 2 hoses to the tent
• Turn on with the switch located on the housing
• Warning!! The blower should never be covered when in use.
• A sufficient air supply should be ensured at all times!
• In order to be able to regulate the amount of air sucked up, the device is fitted with an
  air slider.
  - Loosen wing screw, open the slider slightly
  - Fasten the slider with wing screw
• The air volume conveyed will be reduced proportionately to the degree that the side
  air opening is opened using the slider.