CLOTHING

Go Back

Firedome UST Helmet

Instructions for Providing a Comfortable and Secure Fit
To size the Sure-Lock® ratchet headband:
  1. Turn the ratchet knob counterclockwise until headband is at largest size (Figure 1).
  2. Place the helmet on your head and turn ratchet knob clockwise until headband is snug and comfortable.
To adjust helmet vertically:
  1. Locate the vertical adjustment tabs at the center, rear, back of the headband. There are four tabs on the headband and four white posts on the inner liner (Figure 2).
  2. To raise or lower the headband, reposition the tabs on the white posts and snap in place.

To raise or lower faceshield:

  1. Release tension knobs found on both sides of the helmet.
  2. Tighten knobs once faceshield is in desired position.

Cleaning
Remove ear/neck protector, headband and crown straps. Clean inner and outer shells with mild soap or detergent. Wash the ear/neck protector, headband, brow pad and all crown straps in warm, soapy water and air dry at room temperature. Clean faceshields with mild detergent, rinse thoroughly with clean water and dry with a soft cloth.

Users should not wear helmets that are not thoroughly cleaned and dried.

Decontamination: Contact WFR Wholesale Fire & Rescue Ltd., Customer Service at 800-561-0400 for instructions concerning decontamination procedures.

Caution: Do not use solvents or paint thinners on Firedome helmets as they could permanently mar surfaces or degrade the protective properties of helmet components. Touch-up painting on composite outer shells can be done with Bullard-approved paints.


Back to Top
Click here to go to WFR's Home Page
Copyright © WFR Wholesale Fire & Rescue Ltd.