Go Back

Firedome LT Helmet

Instructions for Providing a Comfortable and Secure Fit

1. Turn the ratchet know counterclockwise until headband is at largest size (Figure 1).
2. Place the helmet on your head and turn ratchet knob  clockwise until headband is snug and comfortable.

1. Locate the vertical adjustment tabs at the center, rear, back of the headband.
2. To raise or lower the headband, slide the height adjuster up or down to set at the desired position for fit (Figure 2).

To raise or lower faceshield:

1. Release tension knobs found on both sides of the helmet.
2. Tighten knobs once faceshield is in desired position.

Cleaning
Remove ear/neck protector, headband and crown straps. Clean inner and outer shells with mild soap or detergent. Wash the ear/neck protector, headband, brow pad and all crown straps in warm, soapy water and air dry at room temperature. Clean faceshields with mild detergent, rinse thoroughly with clean water and dry with a soft cloth.

Users should not wear helmets that are not thoroughly cleaned and dried.

Decontamination: Contact WFR Wholesale Fire & Rescue Ltd., Customer Service at 800-561-0400 for instructions concerning decontamination procedures.

Caution: Do not use solvents or paint thinners on Firedome helmets as they could permanently mar surfaces or degrade the protective properties of helmet components. Touch-up painting on composite outer shells can be done with Bullard-approved paints.