Flow Setting
The washers are marked with various flow settings. Change washer to the
desired setting. The nozzle will flow the indicated amount when the
pressure at the nozzle is at the indicated level.
Washer Setting
To change flow and pressure setting of the Metro, use the following
instructions:
- Set nozzle into flush.
- Push baffle down to barrel cone
- Remove screw and washer using a 5/32 hexkey.
- Remove pre-set flow washer and slide desired flow washer onto shaft,
markings facing up.
- Thread screw with washer back into shaft until snug. (Do not over
tighten.)
|
