A TFT Dual-Force is all conventional handline sizes in one. The wide flow range of 95-100 GPM allows the Dual-Force to be used on 1½", 1¾" or 2" line. In the standard mode, the Dual-Force Nozzle maintains a 100 PSI operating nozzle pressure. The TFT high level of quality, engineered into all our products, allows this nozzle to meet the NFPA #1964 flow requirements for automatic nozzles. This gives you the desired ability to aggressively conduct a hard-hitting fire attack. With an easy twist of the knob on the end of the baffle, you switch to the low pressure mode which immediately reduces the operating nozzle pressure.

This gives you the unique ability to change operating nozzle pressure depending on the situation, thereby allowing greater flow at a lower nozzle pressure. Includes pressure-assisted flush without shutting down, patented slide-type valve for turbulence-free operator flow control, six detent flow positions, molded rubber teeth for full-fill "power fog", and "Gasket Grabber" inlet screen. Integral pistol grip with 1½" waterway is mounted behind the valve. Lightweight hardcoat anodized materials for maximum resistance to corrosion and wear. 1½" NH rocker lug full-time swivel is standard. All Dual-Force TFT's are suitable for use with foam and accept the FJ-H FOAMJET or the FJ-HMX FOAMJET air-aspirating attachments. Part #463526120  1½" coupling, tip only (4.5 lbs, 10") Part #463526130  1½" coupling, twist shutoff (5.1 lbs, 11") Part #463526110  1½" coupling, slide valve shutoff( 6.6 lbs, 13") Part #463526100  1½" coupling, slide valve shutoff, pistol grip--shown above (7.3 lbs, 13") Part #463526140  2½" coupling, slide valve shutoff, playpipe--shown below (9.5 lbs, 15 1/8")

In the standard mode, the Dual-Force Nozzle maintains a 100 PSI operating nozzle pressure.	With a twist of the knob on the end of the baffle, you switch to the low pressure mode which immediately reduces the operating nozzle pressure.

Nozzle Tested
Dual-Force Part #463526100 
Flow range 95-100 gpm, automatic pressure control at 100 psi and emergency
low pressure mode.

Nozzle Tested
Dual-Force Part #463526100
Flow range 95-100 gpm, automatic pressure control at 100 psi and emergency
low pressure mode.

NOTE: Stream trajectories shown are for no wind conditions at 30 degree elevation. Wind can substantially alter the shape and reach of the stream of any nozzle. Effective firefighting range of nozzles is shown. Maximum reach of last water drop is approximately 10% farther. Flow & Reaction Chart Parts Diagram Maintenance & Service Procedure (655KB PDF) Manual  (370KB PDF) Back to Top Copyright © WFR Wholesale Fire & Rescue Ltd.